|
|
|
Development of Divinylbenzene Foam Shells for Use as Inertial Fusion Energy Reactor Targets
Volume 43 · Number 3 · May 2003 · Pages 321-326
Technical Paper · Targets and Target Protection During Injection
Jon Streit, Diana Schroen
ANS Store: Purchase Article
An overview of the present status of development of a hollow foam shell designed to produce high yields when used in a krypton fluoride inertial fusion energy (IFE) reactor is presented. Prototype shells have been produced from a 100 mg/cm3 density CH foam with an ~4-mm diameter and 300  m wall thickness. A triple-orifice droplet generator was used to form the shells using solutions of an internal water phase, an oil phase (divinylbenzene monomer, dibutyl phthalate solvent, and a radical initiator), and an external water phase. The lowest percent of nonconcentricity measured for a completed shell was 3%, and the lowest average percent of nonconcentricity for a batch of shells was 7%. A technique to overcoat the shells with a 1- to 5-m-thick full-density polymer layer using an interfacial polycondensation reaction is being developed. Methods to further optimize dimensions to produce shells that meet IFE specifications are also discussed.
|
|
|
|
