ANS is committed to advancing, fostering, and promoting the development and application of nuclear sciences and technologies to benefit society.
Explore the many uses for nuclear science and its impact on energy, the environment, healthcare, food, and more.
Explore membership for yourself or for your organization.
Conference Spotlight
2026 Nuclear Energy Conference & Expo (NECX)
August 24–27, 2026
Dallas, TX|Hilton Anatole
Latest Magazine Issues
Aug 2026
Jan 2026
2026
Latest Journal Issues
Nuclear Science and Engineering
October 2026
Nuclear Technology
September 2026
Fusion Science and Technology
August 2026
Latest News
Diversification and the common ground
Craig Piercycpiercy@ans.org
Who would have thought, just a few years ago, that we would see so many long-standing barriers to new nuclear development falling like dominoes? Public opinion, policy, regulatory reform, finance and investment, design maturity, nuclear fuel enrichment, and fuel fabrication capacity have all advanced with remarkable speed in the United States.
Conventional wisdom holds that the most effective way to scale up the nuclear supply chain is to do so strategically, matching investments to the needs of reactor developers.
Mohammad Amer Allaf, Abe Whitmeyer, Kenneth Franzese, Riley Elizabeth Soutar, Una Baker, Juliana Pacheco Duarte, Ben Lindley
Nuclear Science and Engineering | Volume 200 | Number 10 | October 2026 | Pages 2279-2295
Research Article | doi.org/10.1080/00295639.2025.2575536
Articles are hosted by Taylor and Francis Online.
The use of accident tolerant fuel (ATF) cladding can increase coping times during and beyond design basis accidents. While such gains may be incremental, they provide a margin that can potentially be recovered to enable high-burnup (HBU) operation. Realizing such a margin requires demonstrating that the combination of HBU and ATF has not led to an overall increase in source term. This study investigates the influence of cladding technology (Zr-based, Cr-coated Zr, and FeCrAl) and fuel cycle length (18 and 24 months) on radiological dose at the boundary of the exclusion zone for a four-loop pressurized water reactor to investigate whether ATF claddings can provide such benefits. We analyze a recovered large break loss-of-coolant accident scenario to investigate the impact of transient timescale on the benefits of such coping time increases. The simulations have been performed using the MELCOR and MELCOR Accident Consequence Code System codes. For the cases analyzed, increased fuel cycle length did not necessarily increase radionuclide release and hydrogen generation, as these were found to be sensitive to the core power distribution. Similarly, off-site dose consequence is dominated by short-lived radionuclides that tend to saturate earlier in the burnup, so higher burnup operation did not necessarily increase the source term for the phenomena and transients analyzed here. Delays in recovery of the low-pressure safety injection system increase hydrogen production and radionuclide release, especially between 780 s and 1620 s, due to the nonlinear oxidation and core degradation behavior. Results show that Cr-coated Zr enhances safety by delaying heatup and gap release. When uncertainty propagation on oxidation properties is considered, FeCrAl exhibits the lowest overall radionuclide release and off-site dose throughout the spectrum. However, while the considered “base model” performance is superior under delayed injection scenarios, upper-bound cases display hydrogen generation risk comparable to the Zr-based cladding.