ANS is committed to advancing, fostering, and promoting the development and application of nuclear sciences and technologies to benefit society.
Explore the many uses for nuclear science and its impact on energy, the environment, healthcare, food, and more.
Explore membership for yourself or for your organization.
Conference Spotlight
2026 ANS Annual Conference
May 31–June 3, 2026
Denver, CO|Sheraton Denver
Latest Magazine Issues
May 2026
Jan 2026
2026
Latest Journal Issues
Nuclear Science and Engineering
June 2026
Nuclear Technology
Fusion Science and Technology
Latest News
NRC proposes changes to its rules on nuclear materials
In response to Executive Order 14300, “Ordering the Reform of the Nuclear Regulatory Commission,” the NRC is proposing sweeping changes to its rules governing the use of nuclear materials that are widely used in industry, medicine, and research. The changes would amend NRC regulations for the licensing of nuclear byproduct material, some source material, and some special nuclear material.
As published in the May 18 Federal Register, the NRC is seeking public comment on this proposed rule and draft interim guidance until July 2.
K. H. Guber, R. R. Spencer, L. C. Leal, P. E. Koehler, J. A. Harvey, R. O. Sayer, H. Derrien, T. E. Valentine, D. E. Pierce, V. M. Cauley, T. A. Lewis
Nuclear Science and Engineering | Volume 139 | Number 2 | October 2001 | Pages 111-117
Technical Paper | doi.org/10.13182/NSE01-A2226
Articles are hosted by Taylor and Francis Online.
For the first time, high-resolution transmission data of 233U have been obtained using a cooled sample. The samples were cooled to T = 11 K using a cryogenic device, which reduced the Doppler broadening of resonances by 50% compared to room-temperature measurements. The measurements were carried out at the Oak Ridge Electron Linear Accelerator over the energy range from 0.6 eV to 300 keV at the 80-m flight path station. Corrections were made for experimental effects, and the average total cross section in this energy range was determined. Results are compared to previous measurements.