The dispersion of gases released to the environment at significant distances from the release point can be predicted using propriety computer codes. However during and after the Preliminary Tritium Experiment1,2 (PTE) at JET in 1991 comparatively high levels of tritium were measured around the buildings and also there was measurable uptake of tritium in the site cooling water. Better assessment of likely tritium concentrations resulting from discharges is required to determine if tritium would tend to concentrate close to the buildings due to the complex air flow patterns around them. Three methods have been considered, namely computational studies, wind tunnel testing and tracer release experiments. A graduated approach has been adopted as each method has its limitations, tracer experiments being particularly expensive. Computational studies indicate that under worst case conditions the maximum ground level concentrations (Bq/m·) per unit stack release rate (Bq/s) is 1.0E-4 but more generally less. The results are presented noting the limitations of this approach. To aid understanding and verify some of the results, wind tunnel tests on a model of the JET site have been undertaken and the results discussed. The need for tracer release studies is considered.